Tagged with "tattoo removal"
Tattoo removal with laser: Laser Q-Switch
Category: General
Tags: tattoo hindi tattoo tattoo removal

Experimental observations of the effects of the short pulses of the laser on a tattoo were first given towards the end of the 60s. In 1978, carbon dioxide was used with limited success and was known to cause scars. An argon laser was used on twenty-eight patients in 1979, but again had limited success.


At the beginning of the 80s of the Q-switched laser was of Dermalase Limited in Glasgow available. Tattoos consist of thousands of particles of tattoo dye that are lifted in the skin. Since the body removes foreign bodies from the skin during its normal healing process, it is unable to remove tattooing particles because they are too large for this natural method. Laser treatments break these particles into smaller fragmented pieces, and this allows the body to remove them by natural methods. There are lots of ways to have some hyginic tattoos and good tattoo. You can find out some of such Hindi tattoos here.

Different tattoo dyes have different light absorption spectra. The laser used in tattoo removal must emit enough energy for the given absorption spectrum of the dye in the tattoo to perform an effective treatment. Yellow, green and daylight fluorescent inks are difficult to remove as a darker black and blue because of their absorption spectra that lies outside of the emission spectra of the laser.

The term Q-switched (Q-switch) refers to short, high-energy pulses of the laser . Q-switched ruby, Q-switched Alexandrite and Q-Switched ND Yag, the latest system advanced in the class of the laser, and particularly in the removal of the red, blue and black inks .

Tattoo removal with laser requires multiple treatments . According to the National Institute of Health , the recent Q-switched lasers are used and scar rarely in connection with a recent anesthetic , but thin areas of skin are more prone to scarring than thicker layers. The lasers developed after 2006 are able to remove a wider range of tattoo dyes than the earlier versions of the Q lasers.

Laser Q-Switch for tattoo removalThe pain relief used during laser removal includes cooling the area to be treated with a medium degree cooler / cooler and a current narcotic. During the treatment, a laser beam passes through the skin harmlessly, aiming only at the ink, which is located in a liquid stand inside. Some immediate results can be seen, but it is for the tattoo usual that it fades gradually over a cure period of seven to eight weeks between treatments .

Laser treatments are on the smaller and older tattoo very successful , because the ink is easier to disassemble. Patients should assume that they must undergo between five and twelve treatments, with at least one period of a month in between. The whole process normally takes between six months to one year.

The laser process can be a painful process , it is often described as a repeated spraying with hot bacon fat or flutter with a rubber band. After each treatment, the skin can look like a burn that heals. Patients should treat the affected area as if it were a burn after the treatment and apply antibiotic creams and keep the area covered. It is vital to keep the treated area out of the sun, either by covering or by using the sunscreen. It is also very important, no scabs, caused by the treatment, to remove , because it will cause scarring. As well as scabies, this treatment can also cause itchy rashes.

RSS

Blog Categories
Recent Comments
No one has commented recently

This website is powered by Spruz